3.Deploy Node Modules

Please place all files in the same directory.

3.1 Modify Node Wallet Address (Very Important)

After extracting the hyperdust-render-windows.zip, use Notepad++ (installed earlier) to open the fileminer\hyperdust-render-windows.zip\application.properties (right-click and choose Notepad++).Modify the wallet address in the configuration section at the bottom of the file to your own address and save it.(When modifying this file, please do not run the hyperdustRenderLauncher.exe program. If it is already running, please close the program before opening this file, otherwise, the modification may fail.)

*Note: The node wallet address is used to receive $HYPT token rewards for providing computing power. Incorrect configuration may result in significant losses. If you are unsure about this operation, consult with an expert.

3.2 Start the Core Module

Double-click on larkXRRenderLauncher.exe to launch the core module. If it fails to start or prompts as a virus, please restart the computer and try again. If it still cannot start, refer to “Chapter 4: Guide to Common Issues.”If the display is as shown below, adjust the computer resolution to 1920*1080 before running larkXRRenderLauncher.exe.

3.3 Check the information in the launcher.

Check whether each item in the environment detection in the launcher has started normally (you can ignore the SteamVR path).You can set whether to automatically start the node service when the computer starts up;（it is recommended to enable automatic startup）.*Note: If this iconappears when running the executable file, you need to modify the Windows group policy (refer to step 3.4) to enable automatic startup on boot (if you do not need automatic startup on boot, please ignore this step).

3.4 Modify Windows Group Policy

Set "User Account Control: Run all administrators in Admin Approval Mode" and "User Account Control: Admin Approval Mode for the built-in Administrator account" to Disabled in the group policy.The settings are shown in the following figure:

3.4.1 Simultaneously press 'Win key + R key' to open the 'Run' dialog, then type 'gpedit.msc' and press Enter to open the Local Group Policy Editor.

3.4.2 Open in sequence: 'Windows Settings' ——'Security Settings' ——'Local Policies' —— 'Security Options'——'User Account Control Admin Approval Mode for the Built-in Administrator account'.

3.4.3 In the Properties window, click 'Disabled'.

3.5 Save Configuration

Open the configuration manager, make no changes, then click "Save and Restart."

3.6 Confirm Startup Status

If it appears as shown in the following figure, the startup status is successful.*Note: Each node needs to be assigned a specific public IP; otherwise, it may result in startup failure.